06
Start-up procedure
Do not use the throttle while dismounted.Avoid accidental application of the throttle
while dismounted; anytime you are moving the bike while dismounted, ensure the
bike is powered off to prevent accidental application of the throttle.
Installation steps
1. Remove the packing EPE
pear cotton.
2. Turn upside down.
3. Remove the fork spacer.(it
protects the fork from crushing
and deformation during
shipping, it's not a part of the
bike.)
4. Put the front wheel on the
fork.
5. Tighten the nuts on both
sides.
6. Turn it over again.
9.Lock closure. 10. Use the bolt to join the headlight.fork arch
and fender.
7. Insert the upper part of the
column into the lower part.
8. Stand the steering column
and lock the column folding
quick release lever.
After the F22Pro has been properly assembled according to the assembly video, all compo-
nents are secured correctly, and you have read this entire manual, turn on the F22Pro and
select a pedal assist level following the steps below:
1. Test the battery lock security.Ensure the key port is aligned with the OFF icon, which
indicating the battery is off and locked onto the frame mount.Carefully use both hands to pull
up on the battery to test that the lock is secure.
2. Turn the F22Pro on/off.Insert the key and turn clockwise to the ON position.Locate the
LCD Display (near the left handlebar grip).Press and hold the lower power button for about
3 seconds to turn F22Pro on/off.
3. Front light:Long press the "+" button to turn on and off the front light.
4. Begin riding carefully. With the proper safety gear and rider knowledge, you may now
operate your F22Pro.
5. The throttle is used by slowly and carefully press the throttle downward. Do not use the
throttle unless you are on the F22Pro.
To Next Page
Loading...
