CLEANING PROCEDURE
CLIPPER 86038240
3-8
Release intermittent trigger switches or
turn off continuous setting on solution
switch approximately 1 foot before ending
cleaning pass.
Push down on handle to raise vacuum
shoe and brush before moving to the next
cleaning pass. Overlap brush contact
area approximately 1inch.
STEP
1
STEP
2
STEP
3
Start at wall closest to power outlet. For
small areas, pull straight back without
pushing down on handle.
1in.
(25mm)
OFF
1ft.
(30cm)
1. This machine can be operated in either
direction. For smaller areas operate the
machine by pulling rearward.
2. For larger unobstructed areas, flip the
handle and use the machine’s brush
assisted propelling motion.
1
2
To Next Page
Loading...
