23
Select “Point Dish/Signal” option “1”. If you do not see signal on your meter, be
sure satellite 91 is selected and try a different transponder. All transponders may
not be active. See Figure 6.1.
Select “Check Switch” from the Point Dish Screen.
Be sure that any options, such as “Alternate” are unchecked. Select “Test.”
The receiver will test the satellite antenna to verify which switch should be in-
stalled. After the test is completed, the check switch screen will report the result.
The switch type installed should be “SW42”. If this switch is not installed cor-
rectly, please run the check switch test again.
6.3 Watching Bell ExpressVU programming
Power on the Winegard Satellite Interface. In a few moments, the satellite
antenna will begin its search routine. It will verify satellites and lock onto Dish
Network satellite 91°W.
If you have an in-motion antenna, the antenna will continue to “track” the satel-
lite for 7 minutes after signal acquisition. After 7 minutes, it will enter sleep
mode. You can watch television as normal while the antenna is tracking. For
instructions on how to force sleep mode, see Section 7.3.
Figure 6.1 - Actual Screen may vary
To Next Page
Loading...
Need help?
General
