44
Troubleshooting
Diagnostic Test
Running a diagnostic test is an option in the SETUP menu. It is used to
check the BirdCam functionality and verify that it is working properly.
During this test, important subsystems are tested.
Run the Diagnostic Test
1. In SETUP menu, press the or button until TEST CAMERA?
appears.
2. Press the + or – button until YES appears.
3. Press or button to activate your selection.
4. When you see the message WAVE HAND NOW wave your hand
about 12 inches from the BirdCam’s infrared sensor. When you
see the message TEST IN PROGRESS stop waving.
Diagnostic Test Messages
After the diagnostic test is complete, a message indicating the status of
the BirdCam will display.
If no problems are detected, ALL SYSTEMS OK will display for
5 seconds.
If a problem is detected, a 6-digit error code will display for 10 seconds,
indicating the status of the BirdCam system.
To Next Page
Loading...
