English AM90
FILTER CARE
2. Removing filters
Turn the unit power off before removing filters.
Remove the front panel by grasping its
upper edge and gently pulling forward.
•
To remove the front panel release the
latch at the lower edge of the panel.
Press the Pre-filter tabs near the top of the
filter, release and remove.
Pull out the Carbon filter and HEPA filter.
3. Preparing New Filters
Remove replacement filters from protective
plastic wrap.
•
Operating the unit without removing
filters from plastic wrap may cause
abnormal noise, deformation, or fire as a
result of overheating.
NOTICE
•
For optimal performance, only Winix filters should be used
with this unit.
To Next Page
Loading...
