Winix ZERO - Removing Filters; Preparing New Filters

FILTER CARE
English
ZERO 14
• For optimal performance, only Winix filters should be used
with this unit.
NOTICE
2. Removing Filters
Turn the unit power off before removing filters.
①
Remove the front panel by grasping its
upper edge and gently pulling forward.
②
Press on the Pre-filter tabs near the top of
the filter, release and remove.
③
Pull out the Carbon filter and True HEPA
Filter.
3. Preparing New Filters
①
Remove replacement filters from protective
plastic wrap.
• Operating the unit without removing
filters from plastic wrap may cause
abnormal noise, deformation, or fire as a
result of overheating.
Latch
Tabs
Pre-filter