Winix ZERO - Filter Service and Replacement Guide

INSTALLING FILTERS
English
ZERO 7
④
Install the filters until they fit securely in
place.
Filters must be installed in this order:
3 True HEPA Filter (rear)
2 Carbon filter (middle)
1 Pre-filter (front)
• To install the Pre-filter, insert bottom tabs
into the slots on either side of the lower part
of the unit, then rotate upward to insert the
upper tabs into the slots at the top part of
the unit until sides audibly click into place.
⑤
Replace the front panel by first inserting
the latch at the bottom edge into the base
of the unit, then rotate the panel upward
toward the top of the unit until the magnets
pull the lid closed.
⑥
When to service and replace filter:
Filter Indicator Light
When to
service
When to replace
1 Pre-filter none
Clean once every
14 days
Permanent
2 Carbon filter none
Can NOT be
WASHED
Replace every
3 months
3 True HEPA filter
Lasts up to
6~12 months
※
Intervals between filter replacement may vary depending on environment.
※
For optimal use, Pre-filter can be cleaned once every 14 days which can
extend the life of other filters.
To purchase replacement
Winix filters:
contact your local dealer
True
HEPA
filter
Carbon
filter
Pre-filter
Latch
this unit
is
compatible
with this
filter
item: 115115
A
FILTER