SECTION 8 –
ENTERTAINMENT
8-2
To Watch DVD
• Power “ON” TV and the high definition video
selection box.
• Power “ON” the DVD player.
• Determine which TV you want to use (e.g.
TV2 for second main TV) and select “DVD”
from high definitionvideo selection box.
• On TV remote control, press INPUT or
SOURCE button and select either
COMPOSITE (for standard definition) or
COMPONENT (for high definition).
The TV will display the DVD logo when the
correct input is selected.
To Watch Satellite TV (Dish)
-If Equipped
• Connect satellite receiver to accessory
connection cables (provided in the prep area).
• Power “ON” TV and the high definition video
selection box.
• Determine which TV you want to use (e.g.
TV1 for main TV) and select “SAT” from the
high definition video selection box.
• On TV remote control, press INPUT or
SOURCE button and select either
COMPOSITE (for standard definition) or
COMPONENT (for high definition).
The TV will display the satellite logo when
the correct input is selected.
AUDIO-VIDEO SYSTEM BASIC
OPERATION
NOTE: For your convenience, we have also
included a handy, tear-out version of this
“A/V System Basic Operation” guide in
Section 8 of your Operator’s Manual
Supplement.
See your InfoCase for specific operating
guides for audio and video components.
DVD HOME THEATER SYSTEM
–If Equipped
The available DVD home theater system
operates from 120-volt AC household current
only, so you must have either the shoreline
connected, the generator running, or the inverter
turned on (if equipped).
The TV is connected to the home theater
system, which plays through theater speakers in
the lounge area of the coach.
Connect Theater
Speakers
• Press the SPEAKERS
switch on the dash to
TV position to connect
the theater speakers to the home theater
system.
NOTE:The Aux. Battery Disconnect switch must
also be on while listening to theater
sound because the audio relay is powered
by house batteries. If the Aux. Battery
Disconnect switch is off, the speakers
will not emit any sound.
Accessory Connection Cables