8-7
SECTION 8 –
ENTERTAINMENT
Checking Amplifier Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter (tower). Signals may vary from
strong to no usable signal at all. We recommend
that the TV system be checked out in an area
known to have good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
is working properly, the TV picture will now be
degraded (snowy). When you turn the switch
back on, the picture should again be sharp.
CABLE TV AND SATELLITE
HOOK-UPS
(Input)
The cable television and portable satellite dish
connectors are located in the utility compartment.
The input lines can be routed through the
hatch in the bottom of the compartment so the
door can remain shut while connected.
TV DIGITAL SATELLITE
SYSTEM WIRING
This coach is pre-wired for installation of a
digital satellite TV system. Coaxial cable and
high definition component cable connections are
available to hook up your satellite receiver and
are located in the entertainment center cabinet.
A second connection may be included in an
overhead cabinet in the bedroom for the rear TV
(if equipped.)
See your authorized Winnebago Industries
®
dealer for proper installation and sealing of roof
mounted components.
TV Signal Amplifier Switch on
Video Selection System
(Typical View)
Exterior Connection for
Satellite Dish and Cable TV
(In Utility Compartment)
Interior Connection for Satellite Dishes
(Located in cabinet near TV)
- Typical View
To Next Page
Loading...
Need help?
General
