SECTION 4 –
APPLIANCES AND SYSTEMS
4-4
At the touch of a button this panel can display
the fresh water and holding tank levels, propane
gas tank level, plus the chassis battery and house
battery condition. You can start the electric
generator or turn on the water pump and water
heater. Indicator lights tell you if the water pump
is on or if the water heater pilot light is out.
Generator Start/Stop Switch
See Electrical Systems section for generator
start-up and shut-down instructions.
Generator Hourmeter
See Electrical Systems section for generator
hourmeter information.
Water and Holding Tank Levels
Press and Hold the appropriate button to show
approximate tank level on the monitor lights
The approximate fluid levels are measured by
sets of electronic sensors (detector cells) on the
sides of the tanks. There is generally more fluid
in a tank than indicated on the monitor panel.
For example, if the fluid level is 1-2” below
the FULL sensor, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If a tank is about 1/4 full, the monitor will
register an empty tank because the fluid level is
below the 1/3 sensor even though there is still
fluid in the tank.
However, when the indicator reads FULL, the
tank is actually full.
OnePlace Monitor Panel
Generator Switch and Hourmeter
Water Tank
Water Level
Sensors
To Next Page
Loading...
Need help?
General
