Winnebago Journey User Guide

SECTION 7 –
PLUMBING
7-10
The fresh water tank drain valve is cable-
operated by pulling on a T-handle located in the
water service center.
Water Heater Drain Plug
The water heater drain plug is located on the
outside of the coach behind the water heater
service panel. Use a socket to remove the plug.
WATER HEATER BYPASS
WINTERIZATION VALVE
Your coach may be equipped with a water
heater bypass valve for easier winterization of
waterlines using RV antifreeze. See Water
System Drain Valve Locations chart at the end of
this section for valve location on your model.
Turn the handle as shown to either Bypass or
Normal flow through the water heater.
WINTERIZING PROCEDURES
You can winterize the water and plumbing
system of your coach using one of the following
two methods – 1) Blow out waterlines using
compressed air or – 2) Fill waterlines with RV
water system antifreeze.
Method 1 – Blow Out Procedure
(Drain and purge waterlines using
compressed air)
1. Level the Motor Home. If the coach is not
level, there may be “low points” in waterlines
that can trap water in the lines and prevent it
from draining properly.
2. Drain Fresh Water Tank and Waterlines.
Open all waterline drain valves and drain
fresh water tank. (See “Water System Drain
Valve Locations” chart at end of this section
for locations of drain valves on your model.)
Water Tank Drain Valve
(pull T-handle to drain
fresh water tank)
Waterline Drains
(remove caps and turn
valves to drain lines)
-Typical View
Water Heater Service Access
-Typical View
Drain Plug
CAUTION
Leave bypass valve handle in NORMAL
FLOW position if draining water and
blowing out waterlines. Place in BYPASS
position ONLY when using antifreeze
solution in waterlines.

Winnebago Journey Specifications

General

Brand	Winnebago
Model	Journey
Category	Motorhomes
Language	English