SECTION 6 –
ELECTRICAL
6-2
The power cord is designed to ground the
electrical system through the receptacle. It is also
designed to carry the amperage output of most
campground outlets. If the electrical receptacle to
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.
Power Cord Door
(Models with power cord compartment on
sidewall)
–If Equipped
A flip-up notch in the power cord door lets
you route the power cord out of the compartment
and close the door while the power cord is
connected.
Power Cord QuickPort
®
(Models with power cord in utility
compartment)
–If Equipped
The flip-down QuickPort hatch lets you route
the power cord out the bottom of the
compartment so you can close the compartment
door while the power cord is connected.
• Swivel the cover section upward to access the
cord notch
• Route power cord through notch and close door
while shoreline is connected to outlet
• Swivel the latch aside and drop the hatch
To Next Page
Loading...
Need help?
General
