Winnebago Via 25Q User Manual

SECTION 6 –
ELECTRICAL
6-6
If the GFCI keeps tripping, have the electrical
system checked and repaired, if necessary, before
using again.
ELECTRICAL GENERATOR –
120-VOLT
To use the 120-volt Generator, plug the power
cord into the Generator receptacle within the
utility compartment before starting the
Generator.
Generator Basic Operation
(LP Generator)
NOTE: If the GenSet Start or Stop switch is
momentarily pressed, the monitor panel
will automatically try to start or stop the
generator.
Refer to the manufacturer’s user guide
provided in your InfoCase for additional
information.
To Start the Generator
Press and Hold the GenSet Start button until
you hear the Generator running smoothly, then
release.
To Stop the Generator
Press and Hold the GenSet Stop button until
you hear the Generator come to a full stop, then
release.
WARNING
The GFCI will not completely eliminate
the risk of electrical shock. Infants and
small children may still be affected.
WARNING
Careless handling of the generator and
electrical components can be fatal.
Never touch electrical leads or appliances
when your hands are wet, or when
standing in water or on wet ground.
Do not attempt to repair the generator
yourself. Service should be performed by
a qualified service center.
• Push to Reset
circuit after
monthly testing
or ground fault
tripping.
• Push to Test at
least monthly.
Should break
circuit. Press
Reset button to
reconnect.
GFCI Outlet
(Ground Fault Protector)
WARNING
Do not plug the power cord into the
generator receptacle while the generator
is running. Electrical shock can cause
personal injury.
Power CordGenerator
Receptacle

Winnebago Via 25Q Specifications

General

Brand	Winnebago
Model	Via 25Q
Category	Motorhomes
Language	English