89007312 11
7 Washing
Before loading the dishes into the rack, first:
• Remove large food residues.
• Load plates facing forward.
• Wash cutlery either vertically in cutlery inserts or horizontally in a flat rack. Make sure that the racks
are not filled too full.
Place knives in the cutlery boiler with the handle at the top.
Pre-soak any heavily soiled cutlery with dried-on food residues.
7.1 Washing with the normal programme
Push the full wash rack into the machine and close the door.
Press programme button (6). The programme button is lit blue while the programme is
running.
The programme button (6) is flashing green when the programme has ended and the
door has not yet been opened. As soon as the door of the machine is opened, the
flashing stops and the programme button 6 switches to a continuous green light.
The flashing programme button (6) indicates that the wash programme is complete and the door has not yet
been opened.
If the flashing disturbs you, the machine control system can be adjusted by an authorised service engineer to
prevent key 6 from emitting the flashing green light.
Open the door and remove the wash rack.
The intrinsic heat of the crockery and the effect of the rinse aid added to the rinsing
water combine to quickly dry the crockery with a bright and shiny finish.
Do not dry recently cleaned dishes with a towel to avoid spreading bacteria and germs.
Close the door once more.
Add more detergent powder
4
:
After 5 wash cycles, the concentration of detergent in the machine will have dropped to
such an extent that optimum results are no longer obtained. More detergent must be
added:
Open the door
Add approx. 45G detergent powder to the filter cartridge using a cup.
Close the door.
4
For machines without liquid detergent dosing only
To Next Page
Loading...
