WT901 | manual v0513 | http://wiki.wit-motion.com/english
2.4.3 Baud Rate
The module supports multiple baud rates, and the default baud rate is 9600.
To set the baud rate of the module, you need to select the baud rate to be
changed in the communication rate drop-down box in the configuration bar
based on the correct connection between the software and the module.
Note: After the change, the module will no longer output data at the original
baud rate. The data will be output only when the baud rate that has been
changed is selected on the PC software again.
To Next Page
Loading...
