Service 16
2.5 Grinders
Right grinder
The grinder right (33 7006 4704) is pre-set to grinding number 1 espresso grinding.
This corresponds to a discharge rate of about 2.2 g/s, and a grain size distribution of about 470 μm
Left and center grinder
The grinder middle and left (33 7006 4703) is pre-set to grinding number 5 Creme grinding.
This corresponds to a discharge rate of 2.6 g/s and a grain size distribution of approx. 640 μm
2.5.1 Grinder - grinding degree setting
1. The setting is made on the grinder when it is completely empty.
2. Grinder with assembled sprocket without shaft bearings and worm shaft; the grinder is not attached to the motor.
3. The disks are turned towards each other until they sit tight to each other and can no longer be rotated around the driveshaft by hand.
4. The shaft bearing with worm shaft is assembled.
5. On the shaft bearing, turn 10 turns (a 360°), this corresponds to grinding number 1– espresso grinding
On the shaft bearing, turn 18 turns (a 360°), this corresponds to grinding number 5 - creme grinding
6. Re-adjust the grinding degree if necessary
To Next Page
Loading...
