28 64.1168.0790 I 002 64.1168.0790 I 002 29
Operating Instructions ENOperating Instructions
e) Lift the lid 6 by the handle B.
2. Take apart the lid (see image series G), by
first turning the lid over 6.
3. Carefully pull the seal ring L out of the pot
's rim and place aside.
4. Hold the lid 6 and press the handle locking
device E towards the end of the handle.
5. Remove the lid 6 by the handle.
5.2 First clean the pressure cooker
1. Take the pressure cooker apart as described in
Chapter 5.1.
2. Fill 2/3 (see inner scaling Image I) of the pot
1 with water and add 2-3 tablespoons of
household vinegar.
3. Boil the vinegar water in the pot 1 without
the lid 6 for about 5-10 minutes.
4. Afterwards, wash all parts thoroughly by hand.
5. Dry all parts well after cleaning.
5.3 Assembling the pressure cooker
CAUTION
RISK OF BURNS CAUSED BY
INCORRECTLY ASSEMBLED LID
The lid cannot be put together incorrectly.
Assembly must follow the manner described.
⇨ Observe the instructions strictly.
⇨ Check for correct fit.
5.3.1 Assemble the lid
(see image series H)
1. Check lid rim, lid handle, safety devices
and seal ring for dirt or clogging.
2. Turn lid 6 so that the rim points
downward.
3. Turn the handle B and hold in place.
4. Insert the holding slot H on the lid
handle B into the lid's 6 holder 8.
5. Slowly fold down the lid 6.
6. Turn lid 6 using the handle B.
7. Position the lid 6 and handle B in such a
way that the double seal I isn't squished or
the edges of the lid opening damaged.
8. Carefully press down lid 6 until it snaps into
place audibly in the handle locking device E.
Check that it is correctly seated by pressing
on the red slider.
9. Insert the seal ring L into the pot's rim and
carefully press under the rim.
▶ The seal ring L must be positioned
completely below the curved pot rim.
5.3.2 Put lid on ((see image series F)
1. Place pot 1 on firm surface.
2. Place lid 6 on the pot 1 with rim facing
downwards.
▶ The placement marking 9 on the lid and the
handle marking 4 must line up, otherwise
the lid cannot be put on.
▶ Seal ring L must be inserted into the lid
rim!
3. Hold the pot's 1 handle 3 with the left
hand.
4. With the right hand, swivel the lid 6 with
the handle B to the left.
5. When both handles 3/B are lined up
exactly on top of each other, push the turn
knob Cforwards completely.
▶ No gap can be visible between the handle B
and the turn knob C.
6. Operating the pressure cooker
6.1 Check safety devices
1. Remove lid 6 as described in Chapter 5.1.
2. Carefully pull the seal ring L out of the pot 's
rim and place aside.
3. Remove lid handle B as described in Chapter 5.1.
4. Check to ensure that the seal ring L and the
inner lid rim are clean.
To Next Page
Loading...
