the locking degree of the clamping lever can be adjusted.
THE ADJUSTMENT OF THE CROSS SLIDE
The abrasion of the cross slide will be compensated by adjusting the
strip inside the slide. Firstly loosen the screw on the big end of the strip,
then fasten the screw on the small end of the strip. When they are
adjusted to the proper condition, fasten the screw on the big end of the
strip again.
FIGGURE3
：
BEARING POSITION
Before operating the lathe, all the parts must be lubricated.
When the lathe is used for the first time, or it is not used for a long time,
keep the machine running for a few minutes.
Never use the lathe in the moist position, keep the lathe clean and also
keep the working site well illuminated.
To Next Page
Loading...