CNC210 Operating Manual
Note:Please read the operation manual carefully before using the
machine.
1.General Instruction
1.1 The scope and purpose of this operation manual .
This manual is written for the flat bed CNC lathe to guide the user to accurately use the
machine which produced by our company , please read it carefully.
In the second part of the manual ,we providing the safety instructions for the operation of the
machine.which the operator can use it as a check item for daily work.
In the second part of the manual,we provide the method of how to install and matters what
we should pay attention to.
In the fourth and fifth part of the manual,you should understand the Technical data and the
Machine tool structure before using .
The sixth part of the use of machine tools and safety protection describes the operation of the
machine tools in the security situation
The seventh part of "inspection and repair" provides the operator with the knowledge and
methods of operation and maintenance of the machine tool.
The eighth part of the "easy-broken parts" provides the machine parts diagram
Please connect with our service or technical department,if any problems doesn’t mention in
the manual.
1.2 The main use of the machine.
The machine is mainly used for processing various kinds of shaft, disk type parts,can be
turned all kinds of thread, arc, cone and the inner and outer surface of the revolving surface, can
meet the needs of high-speed cutting of ferrous and non-ferrous metal materials,Suitable for the
processing of plumbing and heating equipment, valves, electrical appliances, instruments,
automobiles, motorcycles, bearings and other parts of the industry.With high speed, high
efficiency, high reliability, and nice work at the machining parts consistency ,and little influenced
by human factors.Machining accuracy can reach IT6~IT7 level.
1.3 Accuracy of the machine.
The precision of the machine is in accordance with the standard of the JB/T8324.1-1996
simple CNC horizontal lathe
1.4 The using environment of machine .
This machine is suitable for operation under the environment and conditions as specified
below.
A. Ambient temperature:5--40℃
B. Dampness:The maximum temperature of 40℃, the relative humidity shall not exceed
50% of the range
To Next Page
Loading...
