CNC210 Operating Manual
operator and the environment ,the protective doors with transparent material, we can clearly see
the machine’s running situation when in processing.
B: The protection of X and Z axis.
X, Z axis adopts metal protection, can effectively block cutting fluid and scrap iron .
C:Z, X axis has a dead limit, it can avoid errors in the operation and programming data errors
caused by failure, etc.
D:Cooling liquid flows back to the water tank,filtered through the mesh filter cover, you can
filter out most of the iron filings. Inside the water tank is provided with separating strips, the
clastic which didn’t filtered will deposit at one end of the water tank, does not enter the pump.and
please clean the tank regularly.
E: fully closed design electrical cabinet,and it is easy to expansion for the reserved in the
electrical cabinet.
F: The protection of power failure or breakdown.
When machine encounter outside a sudden power failure or failure, the parts which in the
start state will automatically to the stop state, in the stop state will not automatically start.NC
system built in the battery, when the system fault always, storage processing program will not
lost.
H:Machine equip with alarm function and emergency stop button, can prevent all kinds of
sudden failure of the machine caused damage to the machine .NC system will give alarm
signal,we can find the fault location according to the system specification.
6.3 set the necessary safety warning signs
Despite adopting many safety measures, but there will still some potential, not obvious
danger, in order to prompt the operator, we set necessary safety warning signs, please don’t
violate the above tips.
7 Inspection and maintenance
7.1 Routine check
The oil level of the
lubrication parts
1． Whether there is enough oil
2． Whether the oil is polluted obviously
Please add,if the oil is not enough，
replace the oil when polluted
1
．
Whether the coolant level is suitable
2． Whether the coolant is polluted
Whether Sediment has exceeded the height of the
bottom of the water tank.
Please add if necessary
Please replace if necessary
Please replace and clean up if
necessary.
1． Whether the lubricating oil is enough
2． Whether the scraping board is damaged
1.Whether the tension is appropriate
2.Is there a crack or scratch on the surface
The surface of the
bed and pipeline
1.Whether there is oil, water leakage
2.Whether they are unimpeded.
To Next Page
Loading...
