CNC210 Operating Manual
A:Front and behind protection and cooling protection.
B:exceed range limited device(According to the specific configuration)
C:Storage stroke limiting device(NC software)
3.12 The work before repair
Warning:
A: Without permission to do any maintenance work.
B:Replacement parts, vulnerable parts should be arranged advanced.
C:Use right maintenance methods.
Attention:
A:Read carefully and fully understand the safety precautions specified in the manual.
B:Read this manual carefully and understand the relevant principle and contains notes
3.13 Maintenance operation.
Danger :
A:The control power switch on the main circuit breaker or the operation panel shall not be
operated by the personnel who are not related to the maintenance work.In such a switch or other
appropriate places should be hung "no flipping a switch, maintenance!" the warning signs. And
such signs hung on the obvious and not easy to pick the location
B:When maintenance of machine tools, live operation is dangerous, please be careful. Try to
close the main circuit power supply operation
Danger:
A:Electrical maintenance personnel should be familiar with the corresponding business
personnel to play
B:The protective device and the interlock function of the machine can not be removed at
will.
C:Replacement of the electrical components should be strictly in accordance with the list
which provide by the manufacturers.
3.14 The works after maintenance.
Warning：
A：We should clean up and arrange the working environment ,in order to provide a good
working environment ,when we finish maintenance.
B:Remove the parts and clean out the waste oil, waste water should be placed away from the
machine according to the relevant regulations for processing
C:Maintenance personnel should check whether there is a security risk in the operation of the
machine after the completion of the maintenance
D:Record of maintenance and inspection data for future reference.
4 Lifting and Installing
4.1 transport and storage of machine
To Next Page
Loading...
