CNC210 Operating Manual
D: Don’t use hands or clothes in contact with rotating work piece and the main spindle.
E：In the process of automatic ,please don’t open the guard door of the machine.
F:In heavy duty processing, should avoid chip accumulation, because hot chips may cause
fire, heat accumulation will cause the thermal deformation of the machine, affect the processing
precision.
Warning :
A:The operation of the switch is not allowed to wear gloves, may cause malfunction of the
machine.
B: Only after the Tool carrier ,spindle and other parts of the machine is stopped ,can be allow
replace the work piece and tools.
C: Don’t clean up the chip when the machine work.
D:Not allow to open the door or guard cover ,when operation the machine.
Attention :
A:when heavy work piece need to be moved ,you should work with two or more than two
people ,in order to avoid danger.
B:If the work piece need to be moved by elevator or forklift, crane and other similar
equipment,the operator should be trained and approved by the enterprise.
C:Should use the brush to clean the knife cutting head, not directly to clean with hands.
D:Processing of magnesium alloy, the operator should wear gas masks; processing of large
dust materials, should wear masks and other protective equipment
3.9Interrupt processing
Attention:
After the completion of the processing,the operating panel should be on the power switch off,
and disconnect the main circuit switch,when you need leave the machine for a while.
3.10 Finish machining
Attention:
A:don’t clean up the machine before the machine stopped
B:the machine should be clean up after stop working,remove iron, wipe the door, window
cover, etc.
C:Return each component of the machine to the initial position.
D:To check the shaving device whether is not damaged or not, if there is any damage please
replace it immediately.
E:Check the contamination of the coolant and lubricating ,and replace it if necessary.
F:Check the amount and coolant and lubricating oil,please add if necessary.
G:Clean the iron box position filter to prevent clogging
H: please power off the switches,Power switch on the operation panel, the main circuit
switch of the machine tool, and the electric switch of the workshop,when you knock off.
3.11 Safety protection device
To Next Page
Loading...
