CNC210 Operating Manual
C:Please check the protective cover and door and other safety devices are safe, normal work.
D:Please check the belt, if not meet the requirements of the specification, please adjust or
replace. The belt should be intact without damage.
E:The chuck should be locked,before the main chuck running,in order to prevent the chuck
out.
3.6 Temperature rise
Attention:
A:To heat up the machine should be in the state of automatic operation of the machine
without load, the maximum speed of the machine tool movement of half or 1/3 to make the
machine running 10~20 minutes, so that the machine to achieve stable temperature
B:In automatic operation, the machine tool on each moving parts should be in accordance
with the program automatic action, at the same time to check the movement of the various parts of
the movement, should be smooth without abnormal noise.
C:If the machine idle for a period of time, we must carry out the temperature rise of the
machine In order to make the machine tool life lasting, stable and reliable accuracy.
3.7 Preparation before starting
Warning:
A:The tooling should accord with the technical parameters ,no over loading ,or affect the
balance of the machine.
B:Tool wear transition or damage, not only affect the machining accuracy of parts, and will
damage the machine tool, it must always check the tool condition, timely replacement or repair.
C:Processing areas should have good lighting, in order to facilitate the safety detection.
D:Tools and other items around the machine tool should be kept in an orderly, reliable, clean
and orderly environment.
E:tools,work piece and any other items should not put on the spindle box cutter, spindle,
carriage and other similar parts, in order to avoid the accident.
F: the center hole of the work piece should match its weight,so can we prevent the work
piece from sliding out of the center.
Attention：
A:The length should be in the limited range ,so that we can avoid interference.
B:After the tool is installed, try to run, and pay attention to the adjustment of tool parameters.
3.8 Matters needing attention in works
Danger:
A:The operator with long hair ,should wear hat ,and plate the hair in the hat,and avoid the hat
blown off by the exhaust fan .shall not wear gloves,and operator not allow to romp and play.
B:The work piece should be clipped,the wrenches on the spindle and chuck should be taken
down.
C:adjusting the nozzle of the coolant should under the machine shutdown state.
To Next Page
Loading...
