CNC210 Operating Manual
H:you should confirm in advance before you operation the switch,no mistakes,or prone to
accidents. Don’t touch the switch at will.
3.3 Requirement before power supply
Danger:
Cable, coil, wire, electrical components, if there is damage, will produce leakage, causing
electric shock accident. So you should check them carefully before using.
A:you must understand them which were required in the operation and programming
Manual.and you should clear about each function and operation .
B:Wear oil proof, non slip insulated shoes, and other requirements of the safety protection
facilities.
C:Check all NC devices, operating panel, electrical control panel, door and lid should be
closed.
Attention:
A:The cable conductor need have sufficient cross-sectional area,which from the power
supply switch to the total machine power switch.so that it can meet the demand of power
transmission.
B:the cable conductor which dew on the ground should be waterproof, prevent cuts, anti
wear protective measures ,in order to avoid the accidents.
C:we should clean the debris and antirust oil,when we start the machine,after a long-term
shutdown or unpacking machine before the first use.Each lubricating point, should be re-oiled,
and in accordance with the lubrication requirements. The machine should be coated with anti rust
oil neutral before the long-term stop.
D:The oil tank should be not less than the oil standard position, regular inspection and oiling.
E:For lubrication points, types of oil, please refer to the relevant lubrication instructions.
F:Each switch and handle should be flexible and smooth.
G:When the power supply to the machine, in turn connected to the factory power supply
switch, the total machine power switch, the operating board of the system power switch.
H:Check coolant and add coolant if necessary.
3.4 The demand after power supply
When the machine power supply, the NC system of the screen should be lit, display status in
accordance with the state of the NC system specification.
3.5 Routine checking
Warning:
When checking the tightness of the belt, do not extend the finger to the belt and the belt
pulley, easy to press the finger.
Attention:
A:Please check the electrical mechanical system, etc., to ensure that no abnormal noise.
B:Please check all parts of lubrication of machine tools.
To Next Page
Loading...
