CNC210 Operating Manual
The machine adopts waterproof package, and the key parts coated with antirust oil,
packaging box using the anti vibration and impact measures, can guarantee in ℃to 55℃
temperature range safety transportation and storage. But the packaging box absolutely not allow
upside down or tilt more than 50, does not allow violent impact and vibration, so as to avoid
damage to the internal device.
4.2 Preparation before installation
4.2.1 Environments for the machine
Machine tools should not be placed in the following position:
A:Temperature has a significant change in the environment, such as direct light or near a
large heat source
B:high humidity place.
C:dust is too big, too dirty place.
D:the machine around have punch and other types of source place,If the machine installation
near the location of the source ,must dug anti vibration ditch or a similar measure of anti
vibration.
4.2.2 Environment demands of NC system.
temperature 5 degrees C ~40 C; relative humidity below 50%.
4.2.3 power interface
The power line connecting terminal is located on the outside of the machine tool electric
cabinet.
4.3 Install
4.3.1 lifting schematic diagram shown below
To Next Page
Loading...
