CNC210 Operating Manual
Attention: The best way to adjust the install position is the forklift.
Note: using the circular vibration pad iron (Random)
4.3.2 lifting requirements
The machine and the packing box is not recommended for lifting and adjusting the
installation position, it is best to use a forklift truck, if not to have to be suspended, please pay
attention to the following requirements.
A:Hoisting machine should be especially careful, avoid shock and impact especially the NC
system of the machine tool, control circuit plate, electrical components. Before lifting should
inspect each part of the machine is fixed, the machine tool tail stock should lock, the door to
appropriate fixed, no freely objects on the machine , some accessories and do not belong to the
objects of the machine itself should be removed.
B:Lifting boxes must be in accordance with the outer container lifting sign,steel wire shall
not serious squeeze packing box, not to have access to the machine, and minimize the packing
box subject to impact and vibration. Packing crates tilt shall not exceed 15 degrees. You are not
allowed to take the machine box on the objects with edges and corners or upside down, so as not
to affect the machine's accuracy. Using roller moving boxes on the slope, roll bar diameter shall
not be more than 70mm.
C:the first thing you should do is checking the external conditions of the machine tool,
according to the packing list and the tool is complete.
D:To keep up the machine or the packing box to keep balance in all directions,and should do
adjust when the machine hanging from the ground.
E:The included angle of the hoisting wire rope shall not be more than 60 degrees.
F:When the machine is operated, the operator should be coordinated.
G:when using the forklift ,we also need to follow the above considerations.Forklift should try
to slow down the speed, avoid fast start, stop the inertia in the runaway phenomenon. Driving
forklift personnel must be after the training of qualified drivers, driving the process should be
cautious, careful not to hurt the cooperative work, don't bump machine, so that the machine
excessive tilt.
4.4 Install of the machine
The method of install the machine will have a great effect to the function and
performance,improper installation will make the machine can not meet the requirements of the
processing accuracy, or can not maintain a long-term accuracy requirements.Must carefully read
the installation steps, and refer to the requirements of the installation of the machine in order to
make high precision machining.
4.4.1 Foundation
The position of the machine should be level, and then determine the installation space
according to the specified environment and the shape of the machine tool, and finish the job of the
foundation.
To Next Page
Loading...
