To Next PageTo Next PageWhat does CRC defaul values fault mean on my Wolf CGB-24 Boiler?
If your Wolf Boiler displays a CRC default values fault, it indicates that the EEPROM record "Master reset" is invalid. To resolve this, replace the control PCB.
How to fix TBV excess temperature on Wolf CGB-24?
If your Wolf Boiler shows a TBV excess temperature error, it means the flow temperature has exceeded the limit for TBV shutdown, possibly due to a severely contaminated heat exchanger. To resolve this, check the system pressure and heating circuit pump. Also, check the HC pump step switch, vent the heating system, and then press the reset button.
What to do if my Wolf CGB-24 shows TW excess temperature?
If your Wolf Boiler displays a TW excess temperature error, indicating that the flow/return temperature has exceeded the limit for TW shutdown, check the system pressure and vent the heating system. Additionally, set the pump to stage 2 or 3.
What to do if my Wolf Boiler gas fan doesn't stop?
If the gas fan in your Wolf Boiler does not stop, check the gas fan supply cable and the gas fan itself. After checking, press the reset button.
What causes TBA excess temp. in Wolf CGB-24 Boiler?
If your Wolf Boiler is showing TBA excess temp, it means that the flue gas temperature has exceeded the limit for TBA shutdown. Check for correct installation of the combustion chamber pot.
What to do if my Wolf Boiler gas fan does not reach the required pre-purging speed?
If the gas fan in your Wolf Boiler does not reach the required pre-purging speed, check the gas fan supply cable and the gas fan. Then, press the reset button.
What does Incorrect BCC mean on Wolf Boiler?
If your Wolf Boiler shows Incorrect BCC, it means that the boiler coding card is incompatible with the control unit PCB, so refit the correct parameter plug.
What to do if my Wolf Boiler shows Gas valve „1“ fault?
If your Wolf Boiler displays a Gas valve "1" fault, and a flame is recognized 15 seconds after burner operation even if gas valve 1 has received a shutdown command, replace the gas combination valve.
What to do if the flow sensor is faulty in my Wolf CGB-24 Boiler?
If the flow sensor in your Wolf Boiler is faulty, meaning the flow temperature sensor or lead is faulty, check the lead and the flow sensor.
What to do if my Wolf Boiler has a fault in the 24 VAC supply?
If your Wolf Boiler indicates a fault in the 24 VAC supply, meaning the 24 V AC supply is outside the permissible range (e.g., short circuit), check the three-way valve and the gas fan.
Provides basic details about the gas fired condensing boiler and its safety features.
Covers critical safety procedures for gas leaks, flue gas, electrical work, and system protection.
Guidelines for installing, modifying, and protecting the boiler from corrosion.
Instructions for cleaning the boiler and arranging regular maintenance with a qualified contractor.
Procedure for filling the heating system with water and checking the system pressure.
Details on fitting and filling the siphon for the boiler's operation.
Instructions for operating the maintenance and gas shut-off valves.
Guidance on regularly checking the heating system water level and pressure.
Identifies the main components of the boiler's control panel, including indicators and selectors.
Explanation of the illuminated ring's status indicators and their meanings.
Details on operating modes like summer/winter, emissions test, and temperature selector settings.
Provides advice on saving energy, including pump usage, maintenance, and temperature settings.
Guidance on setting room temperatures accurately for comfort and energy savings.
Explains the importance of adequate air circulation around radiators and sensors for system effectiveness.
Tips for reducing heat loss through windows, ventilation, and radiator efficiency.
Guidance on optimal DHW temperature, continuous handling, and troubleshooting fault codes.
General
