To Next PageTo Next Page
Need help?Do you have a question about the Wolf CGW-2 and is the answer not in the manual?
General| Type | Condensing Boiler |
|---|---|
| Fuel Type | Natural Gas / Propane |
| Efficiency | Up to 98% |
| Gas Connection | 1/2 inch |
| Electrical Supply | 230V, 50Hz |
| Protection Class | IPX4 |
| Vent Diameter | 60/100 mm |
German instructions for combustion chamber cover alteration for specific gas condensing boilers.
English instructions for combustion chamber cover alteration for specific gas condensing boilers.
French notice for combustion chamber cover transformation for specific gas condensing boilers.
Spanish instructions for combustion chamber cover conversion for specific gas condensing boilers.
Illustrates product versions for 2013-2015 and the subsequent 2016 model.
Details the contents of the delivery kit and provides a feedback form for the installation.
Displays critical safety symbols and warnings related to the installation process.
Illustrates the sequence of actions to navigate the device menu and access parameters.
Lists specific factory and customer settings for various parameters (HG01-HG60).
Outlines the necessary preparatory actions before proceeding with the main alteration.
Details initial alteration steps from 6 to 11 presented on this page.
Covers dimensional checks and component fitting steps 12 and 13 presented on this page.
Illustrates version comparison and final checks for steps 14 and 15 presented on this page.
Details connection and electrical work for steps 16 through 19 presented on this page.
Shows component positioning and fastening for steps 20 to 22 presented on this page.
Explains the return process and includes a feedback form for the conversion.
Shows how to insert the parameter connector into the GBCe module.
Illustrates the removal and insertion of the GBCe module.
Guides on identifying the correct GBCe module and verifying its compatibility.
Demonstrates the correct installation of the GBCe module with an audible click.
Shows how to secure the GBCe module in its housing.
Illustrates the action of turning the device ON after parameter changes.
Guides on setting specific parameters FC 37 and FC 39 with a code.
Shows how to start the BCC copying process on the device.
Explains how to perform a BCC check and input the BCC ID from the type plate.
Flowchart for confirming gas settings, potentially related to HG44.
Illustrates a question regarding gas presence and a safety warning.
Guides through the 100% calibration process for the device.
Provides a table of CO2 and Lambda values for different gas types during measurement.
Indicates the completion of the alteration process.
Shows a confirmation of the successful completion of the alteration.
