Wolf FGB Series - Operation via the Control Unit; Control Unit Display Menu; Operating Mode Button

Operation via the control unit
06 | WOLF GmbH 3064461_201903
2 Operation via the control unit
If the appliance is connected to a BM-2 the setting functions are deactivated. The BM-2 takes over these
functions.
Please
note
Emissions test mode
(To enable, press and hold buttons
simultaneously for 5 s)
- The boiler runs under full load for 15 mins.
- Press "Reset" to disable.
Display menu Reset
- Reset
(Press1xbriey)
- Bring up contractor level
(press and hold for 10 s), only
for contractors.
Operating mode button
Standby (OFF)
Summer mode
Winter mode
Only DHW heating enabled
The boiler is switched off,
only frost protection is
enabled.
Heating and
DHW heating enabled
- Select code
- Display code value
- Display code