CONVECTION MICROWAVE CONTENTS
1 Assembly, frame
4 Stud, ball
4 Insert, threaded
3 Assembly, duct (bottom, rear, and top)
1 Template
12 Screw
STANDARD MICROWAVE CONTENTS
1 Assembly, frame
4 Stud, ball
4 Insert, threaded
1 Assembly, duct (bottom)
1 Template
2 Screw
M SERIES MICROWAVE TRIM INSTALLATION
1
For a standard microwave proceed to step 7.
2
Insert the horizontal duct into the vertical duct to create
the rear duct assembly and secure with one screw.
3
Remove the existing screws from the upper right and
left rear of the microwave.
4
Position the rear duct assembly on the microwave and
install the screws.
5
Position the three remaining duct sections on top of the
microwave to create the top duct assembly.
6
Secure each section with two screws (one per side) and
insert one screw in the top section.
7
Install the bottom duct assembly. The duct must be
recessed from the front edge of the opening. Refer to
the chart below. NOTE: For black trim only, the center
of the duct must also be offset
3
/
8
" to the right of the
centerline of the opening.
Microwave
Recess Depth
Convection
3
/
4
"
Standard
1
/
8
"
M Series Microwave Trim Installation
www.subzero-wolf.com 800.222.7820
9018827 REV-B TINSKB244MRR2 10/2018
Page 1 of 2
*9018827$REVB$$$$
$TINSKB244MRR2*
To Next Page
Need help?
General
