12
Operating Procedures
The battery of the Vela and Vega bicycles are fully integrated into the frame.
The removal of the battery requires a key to be inserted on the left side of the
frame. Turning the key 180* unlatches the battery in the rst step. The battery
is now unlocked from the frame and requires a second step of swinging a safety
catch that is visible on the underside of the frame. Be certain to have the battery
in hand to prevent it from falling out.
The installation of the battery is done by rst placing the key in the frame and
putting the lock in the ‘unlock’ position. Then place the bottom of the battery
inside the frame and then raising the top and with a gentle push into the frame
until you hear a ‘click’. The key will now be turned 180* and this will lock the
battery to the frame. Give a tug on the battery to check for t and looseness.
Turn on the display to check that there is power to the bicycle.
Installation and removal of battery
Your Wol charger has a standard North American household plug and ts 120v
electrical sockets in the US and Canada. The battery has a jack type plug that
ts Wol batteries. The charger has a LED light. This light indicates the battery
is charging when it is Red. When the charge is complete the light is Green. This
is an easy visual indicator that it is time to unplug the charger. Do not leave
charging batteries unattended or charging longer than necessary. Batteries can
be charged while installed on the bike or removed from the bicycle. From a low
charge the battery can take up to 4 hours to fully charge.
Charging the Battery
To Next Page
Loading...