Electrical Installation
3-6 WM doc 1/20/21
3
6. Set the grinder motor switch to the “on” position. The grinder motor should come on. Con-
firm that the motor rotates in the direction indicated by the directional decals on the sharp-
ener.
Troubleshoot the electrical installation with these tips:
If a switch in the control box does not work properly, check the connections listed
above. Also, check the fuse in the wiring harness near the positive battery alligator
clip.
To replace the fuse, use a 20 amp ATO type (Wood-Mizer part #P667).
If a control still does not operate properly, contact your nearest service dealer for
assistance.
FIG. 3-3
jog switch
cam motor
switch
grinder motor
switch
To Next Page
Loading...
