Grinding Wheel Installation
WM doc 1/20/21 3-11
3
10. Replace the wing nuts on the top and side of the cover.
11. While supporting the motor:
a. Rotate the sharpener head back into the previous position.
b. Re-attach the turnbuckle assembly to the sharpener head.
c. Replace the wing nut that attaches the turnbuckle to the head.
CAUTION! When disconnecting or reattaching the sharpener head, be
sure to keep it supported. Do not allow the sharpener to fall. It may
damage the grinding wheel or the blade, and may cause personal
injury.
12. Loosen the thumbnut.
13. Twist the turnbuckle to adjust the position of the sharpener head so that the grinding
wheel does not contact the blade.
14. Tighten the thumbnut to lock the turnbuckle into place.
DANGER! Ensure all guards and covers are in place and secured
before operating the sharpener. Failure to do so may result in serious
injury.
FIG. 3-7
thumbnut
turnbuckle
grinding wheel
jam nut
washer
To Next Page
Loading...
