To Next PageTo Next PageWhy are boards thick or thin on ends or middle when using Wood-mizer D34 Saw?
If boards cut by your Wood-mizer Saw are thick or thin on the ends or middle, take equal cuts off opposing sides after the log has been squared. Remove a board, repeat, keeping the heart in the middle of the cant, making it your last cut. Resharpen and reset the blade if there's a set in the teeth. Realign the sawmill if the bed rails are misaligned.
What to do if up/down or power feed motors do not work on Wood-mizer D34?
If the up/down or power feed motors on your Wood-Mizer Saw do not work, replace the drum switch or remove the control panel cover and clean the contacts if the contacts in the drum switch are worn. Replace the motor if it is burned out. Check for loose wire or terminal connections on the battery.
What causes the lumber from Wood-mizer D34 to not be square?
If the lumber from your Wood-mizer Saw is not square, adjust the side supports to be square to the bed. Ensure the blade is parallel to the bed rails, remove any sawdust or bark between the cant and bed rails, and resharpen and reset the blade to address tooth set problems.
What causes the Wood-mizer D34 battery to not stay charged?
If the Wood-Mizer Saw battery will not stay charged, ensure the key switch is OFF when not in use. Check for shorts in the system and have the charging system checked by an authorized Onan dealer. Also, check fluid levels in the cells and add proper solution, adjust the low end RPM, and check for loose wires on the alternator light, replacing it if necessary.
Why do Wood-mizer D34 blades break prematurely?
If Wood-mizer Saw blades break prematurely, replace worn blade wheel belts (B-57) if they are contacting the metal pulley. Ensure proper sharpening techniques are used (refer to the Sharpener Manual). Also, ensure the blade tension is set to the recommended specifications.
What to do if Wood-mizer D34 makes wavy cuts?
If your Wood-mizer Saw is making wavy cuts, try slowing the feed rate. Resharpen the blade, ensuring you consult the Sharpener Manual. Adjust the blade guides, use water lube to address sap buildup, and resharpen and reset the blade to correct tooth set issues.
How to prevent Wood-mizer D34 blades from dulling quickly?
To prevent Wood-mizer Saw blades from dulling quickly, ensure you clean or debark logs, especially on the entry side of the cut. If grinding teeth, grind just enough metal to restore sharpness and use water/coolant. Also, ensure proper sharpening techniques are used.
Why do drive belts wear prematurely on Wood-mizer Saw?
If the drive belts on your Wood-mizer Saw wear prematurely, align the pulleys if the engine/motor and drive pulleys are out of alignment. See Section 4.6 for instructions.
What to do if drive belts come off pulleys when disengaging blade on Wood-mizer D34?
If the drive belts come off the pulleys when disengaging the blade on your Wood-mizer Saw, adjust the brake strap if it is too loose. Realign the brake drum on the drive shaft if it is misaligned. Also, adjust the brake strap if it's tightened unevenly.
How to fix fluid leak around pump box of Wood-mizer D34 Saw?
General| Hydraulic System | Optional |
|---|---|
| Max log diameter | 34 inches |
| Engine Power | 25 HP (18.5 kW) |
| Blade Thickness | 0.042 inches |
| Power options | Electric or gas engine |
