Why is the up/down elevator excessively slow on Wood-mizer LT40HD?
If the up/down elevator on your Wood-mizer Saw is excessively slow, adjust the vertical wear pads and adjust the belt to be as loose as possible without slipping.
What to do if blade does not track right on Wood-mizer LT40HD?
If the blade on your Wood-mizer Saw does not track right, readjust on the Drive Wheel if the cant adjustment is incorrect. Replace B-57 belts if flat or worn belts are the cause.
Why do drive belts wear prematurely on Wood-mizer Saw?
If the drive belts on your Wood-mizer Saw wear prematurely, align the pulleys if the engine/motor and drive pulleys are out of alignment. See Section 4.6 for instructions.
How to prevent Wood-mizer LT40HD blades from dulling quickly?
To prevent Wood-mizer Saw blades from dulling quickly, ensure you clean or debark logs, especially on the entry side of the cut. If grinding teeth, grind just enough metal to restore sharpness and use water/coolant. Also, ensure proper sharpening techniques are used.
What to do if Wood-mizer LT40HD Saw makes wavy cuts?
If your Wood-mizer Saw is making wavy cuts, try slowing the feed rate. Resharpen the blade, ensuring you consult the Sharpener Manual. Adjust the blade guides, use water lube to address sap buildup, and resharpen and reset the blade to correct tooth set issues.
Why do Wood-mizer Saw blades break prematurely?
If Wood-mizer Saw blades break prematurely, replace worn blade wheel belts (B-57) if they are contacting the metal pulley. Ensure proper sharpening techniques are used (refer to the Sharpener Manual). Also, ensure the blade tension is set to the recommended specifications.
What to do if blade does not stop immediately after disengaging on Wood-mizer LT40HD Saw?
If the blade on your Wood-mizer Saw does not stop immediately after disengaging, adjust the brake strap.
Why does Wood-Mizer Saw cut out and then work again?
If everything works and then cuts out and works again on your Wood-Mizer Saw, check the connection in the battery.
Why does height adjustment jump on Wood-mizer Saw?
If the height adjustment on your Wood-mizer Saw jumps or stutters, lubricate the mast track surface. Adjust the up/down chain, adjust the vertical wear pads if they are too tight and adjust belts if drive belt(s) loose.
Why are boards thick or thin on ends or middle when using Wood-mizer LT40HD Saw?
If boards cut by your Wood-mizer Saw are thick or thin on the ends or middle, take equal cuts off opposing sides after the log has been squared. Remove a board, repeat, keeping the heart in the middle of the cant, making it your last cut. Resharpen and reset the blade if there's a set in the teeth. Realign the sawmill if the bed rails are misaligned.
General| Brand | Wood-mizer |
|---|---|
| Model | LT40HD |
| Category | Saw |
| Language | English |
To Next Page