MAINTENANCE
The MP360 is easy to maintain as 95% of the
planer/moulder is protected against rust. The
maintenance required, is mentioned below.
Ensure that the power to the planer/moulder
is switched off before beginning maintenance.
After each work session:
• Clean chips from the planer/moulder. Also re-
move any chips from under the planer/moulder.
• Clean any resin off the table. Use mineral spirit
if necessary. Lubricate the table with paraffin
oil, for example.
MAINTAIN AT REGULAR INTERVALS AS
FOLLOWS
Lubricate these areas regularly:
• Feed roller Bushings.
• Sprockets, including top and bottom layers.
• The chain for setting table height.
• The chain driving the feed rollers.
• The two bars that the moveable slide runs on,
as well as the slide's trapezoidal thread.
• Cast iron table.
Check that all screws and bolt connections
are tightened and that cables and electrical
connectors are in good condition.
USING OR STORING IN COLD OR DAMP
ENVIRONMENTS
If the planer will be stored in a cold or damp en-
vironment over a longer period, all corrosive
parts must be treated with a rust inhibitor.
Cover the planer.
To Next Page
Loading...
