GENERAL
• Check the molder/planer as soon as you
receive it. Report any transport damage to the
transport company immediately.
• LIFT THE PLANER/MOULDER using a fork-
lift or pallet jack.
• When replacing spare parts, use only original
parts and note that anything electrical must
be assembled by a qualified electrician.
APPLICATIONS
The planer/moulder can be used for planing/
molding and planing wood, chipboard, board, etc.
Hard materials such as chipboard, teak, MDF,
etc. require hard carbide tools.
The planer/moulder is designed for indoor use,
with temporary outdoor use.
ENVIRONMENTAL REQUIREMENTS
The temperature in the premises should be above
freezing, unless special measures are taken.
Ventilation in the premises must be mechanical,
and of a good standard.
The planer/moulder must be connected to a
chip extractor.
SAFETY DISTANCE
Other than the operator, no one should
be within 3 meters (10 foot) of the
planer/moulder's sides or 8 meters (26
foot) from the in and outfeed sides
during operation. Mark a limit that
prevents anyone accidentally wandering
into the risk area.
TIPS: An extended infeed table is practical to
use, and prevents anyone coming into the risk
area.
To Next Page
Loading...
