GB
14
Operating Instructions
PROBLEM SOLUTION
Dehumidier does not start - Check that dehumidier is connected to electricity and that fuse has not gone
- If the warning light is on, check that the water reservoir is empty and correctly placed in the dehumidier.
Check that oat is free
Does not dehumidify - Check that fan is spinning
- Check that air can ow freely through the dehumidier. Top grid and air lter should be clean and dehumidier should stand 30cm from walls.
- Listen for sound of compressor, but bear in mind that the dehumidier may stop, when the ambient humidity reach the setting humidity.
- Check that a thick coating of ice has not formed on the cooling coils.
High noise level - Increase distance between dehumidier and surrounding surfaces
- Cooling coils may be in contact with one another and cause vibration. Disconnect dehumidier from electricity and separate coils.
Does not turn o when water
reservoir is full
- It is important that the oat moves freely in the water reservoir. If it does not, it will not respond to water levels and prevent dehumidier from stopping
No water enters reservoir - Check for obstruction to drip-tray above water reservoir
FL - Water reservior is full. Empty the water reservior and put it back.
E1 - Temp-humidity sensor failure. Replace the temp-humidity sensor.
If none of the above works, you should contact your nearest retailer for checking and possible overhaul of dehumidier.
MDX14
Max. working area 40m
2
Air flow step 1 100m
3
/h
Air flow step 2 120m
3
/h
Dehumidifying at 20˚C and 70% r.h. 6,0 l/ 24h
Dehumidifying at 30˚C and 80% r.h. 10 l/24h
Power at 20˚C and 70% r.h. 180 W
Power consumption at 20˚C and 70% r.h. 4,3kWh/24 h
Tank volume 1,5 liters
Refrigerant R290
Charge R290 40 g
Voltage 220-240V
Frequency 50Hz
Current 1A
IP-Code IPX2
Noise level in decibels 43dB
Weight 9,1 kg
Dimensions in mm, L x Bx H 293x183x493
TECHNICAL DATA
*Technical changes and improvements may occur.
All values are approximate and may vary due
to external circumstances such as temperature,
ventilation and humidity.
NOTE!
Register at www.warranty-woods.com
and read about how to get
extended warranty. Please visit
www.woods.se for more information.
Recommended limits for use
Temp. +5˚C to +35˚C
Relative humidity: 30% to 90%
Recommended humidity level:
appr. 50% RH
Guarantees
2 years consumer warranty against production faults.
Please note that the warranty is only valid upon the
production of the receipt. The warranty is only valid if
the product is used in accordance with the instructions
and security warnings expressed in this manual. The
warranty does not cover any damages caused by
improper handling of the product.
NOTE: The 2 years warranty only applies for consu-
mers and not for commercial use of the unit.