Woods MRD10 User Manual

Operating Instructions
GB GB
11
PLACEMENT OF DEHUMIDIFIER
- The dehumidifier should not be placed
near radiators or other heat sources or
exposed to direct sunlight, as it will reduce
performance.
- Ideal is to put it in the centre
of the room / area.
NOTE: When placed in a shower
room or bathing area, the dehumidier
should be xed in place. It is compulsory
to check and respect your local
bathroom electrical regulations before
use.
USING THE DEHUMIDIFIER
If the dehumidier is transported
horizontally, let the dehumidier stand
for a 4 hours before being used. It is very
important that the oil runs back into the
compressor, otherwise the dehumidier
may be seriously damaged.
1. Check that the water reservoir is correctly
placed.
2. Connect the dehumidifier to an grounded
power source.
3. Set the desired humidity level by means of
the humidity control. See the section on the
humidity control.
NOTE: The ambient relative humidity
can be simply measured with the
dehumidier.
OPERATION MANUAL
1. Power Button: This button can control
the machine on and o.
2. Humidity button: To set the desired
humidity
3. Humidity Settings: Open the air outlet
set humidity between 40%, 50%, 60%
or continuous mode.
4. Timer: When the appliance is on,
press the Timer 2H/4H/6H to operate
a countdown.
WATER DRAINAGE
When the water reservoir is full, the
dehumidier is shut o automatically.
Once the water reservoir is emptied the
unit will automatically restart.
1. Disconnect the dehumidier from the
power source.
2. Empty the water reservoir.
3. Put the empty water reservoir back
and check that the oat moves freely.
4. Connect the dehumidier to the
power source.
Direct water drainage
Connect a water hose to the pipe on the
back of the dehumidier. Lead the other
end to a drain. Make sure that the water
can be drained downwards.
AIR FILTER
The air lter prevents dust and dirt from
entering the machine, prolonging its life
expectancy. It
is important the lter is cleaned regularly.
Filter cleaning:
1. Remove the lter.
2. Wash it with warm water and a mild
cleansing agent. Alternatively the
lter may be vacuum cleaned.
3. Let the lter dry and put it back.
DEFROSTING OPERATION
During the defrosting operation, the
dehumidification function may intermit.
Please don’t turn off the switch or pull out the
power plug of the dehumidifier during the
defrosting operation. This dehumidifier can’t be
applicable to keep extreme low temperature.
The purpose of this dehumidifier is to pump off
the unpleasant high humidity in daily life and
dry the wet things. But it can’t be used to keep
extreme low temperature.
The room temperature increases during the
operation.
This dehumidifier doesn’t have colling function.
It will produce heat during the operation and
increase the room temperature to 1 to 4°C. In
addition, the door and windows are closed and
other appliances in the room can give out heat
as well as the radiation of the sun can raise the
room temperature.

Woods MRD10 Specifications

General

Brand	Woods
Model	MRD10
Category	Dehumidifier
Language	English