Woods MRD10 - Installation; Setup and Location

Operating Instructions
GB GB
9
2. Installation
BEFORE FIRST USE
Let the machine stand for 4 hours before use
Selecting a Location
Important
1. Dehumidier must be operated in an
enclosed area to be most eective.
Close all doors, windows, and other
outside openings to the room. The
eectiveness of the dehumidier
depends on the rate at which new
moisture-laden air enters the room.
2. Place dehumidier in a location that
does not restrict airow through the
front of the unit.
3. A dehumidier operating in a
room will have little or no eect
in drying an adjacent enclosed storage
area, such as a closet, unless there
is adequate circulation of air in and
out of the area. lt may be necessary
to install a second dehumidier in the
enclosed area for satisfactory drying.
4. Ensure that the unit is placed on a stable
and at surface. If the surface is not stable
there is a risk that the unit may be unstable
and cause excessive vibration and that water
will be released.
5. The dehumidier must have at least 20 cm
free space around the entire dehumidier.
SET UP DEHUMIDIFIER FOR INSTALLATION
IMPORTANT: