Need help?Do you have a question about the Woodward UG-10 Dial and is the answer not in the manual?
General| Brand | Woodward |
|---|---|
| Model | UG-10 Dial |
| Category | Controller |
| Language | English |
Provides an overview of UG Dial governor types, oil pressure, and general operation similarities.
Details the UG governor's function, output shaft travel, isochronous operation, speed droop, and load limit.
Specifies conditions for mounting the governor, including shaft alignment and clearance.
Details how to connect the governor's output shaft to the fuel linkage for proper control.
Provides guidance on selecting and filling the governor with the correct lubricating oil.
Details the compensation system's role in providing governor stability and steady-state control.
Explains how the load limit control restricts fuel supply or shuts down the engine.
Describes the synchronizer's function for adjusting engine speed or load.
Explains speed droop for stability and load balancing in parallel systems.
Steps for putting a new governor into service, including oil fill and initial settings.
Outlines normal adjustments for stability and response, emphasizing factory calibration.
Details adjustments for the compensation needle valve and pointer to ensure stability.
Explains how incorrect compensation or needle valve settings affect governor stability.
To Next Page