If the battery pack fails to charge, check for the following:
• Voltage at the socket-outlet
• Proper contact at the charging contacts in the battery charger
If the battery pack still fails to charge, send
• the battery charger
• and the battery pack to our customer services department.
To ensure that the battery pack provides long service, you should take
care to recharge it promptly. You must recharge the battery pack when
you notice that the power of the cordless equipment drops.
6.2 Torque setting (Fig. 4/Item 1)
The cordless screwdriver is fitted with a mechanical torque selector.
The torque for each screw size is set with the setting ring (1). The torque
is dependent on a number of factors:
• On the type and hardness of the material involved
• On the type and length of the screws used
• On the requirements that the screw connection has to satisfy
The grating disengagement of the coupling indicates that the selected
torque level has been reached.
Important! Only ever adjust the setting ring when the equipment is
at a standstill.
2 3
8
5
1.
2.
12
5
a
WZAS_14_4_1_Li_UK_SPK7.indb 19 30.07.12 08:50
To Next Page
Loading...
Need help?
General
