Sound pressure level L
pA
: 77.8 dB (A)
Uncertainty K
pA
: 3 dB (A)
Device weight: 41.5 kg
Article number: 94243
The noise emission data were determined in accordance with EN ISO 2151:2008.
The noise level may increase by
1 to 10 dB (A) depending on the environment where the compressor is set up.
• The compressor fulfils the requirements of EN 61000-3-11 and is subject to con-
ditional connection. This means it is not permitted to use the device with freely
selected connection points.
• In the event of unfavourable grid conditions, the compressor could produce tem-
porary fluctuations in voltage.
• The compressor is only designated for use with connection points that
a) do not exceed a maximum permissible grid impedance Z
max
< 0.322 Ω,
or
b) have a continuous grid current-carrying capacity of at least 100 A per phase.
• Make sure that the connection point which the compressor is to be connected to
fulfils one of the two specified requirements a) or b). If necessary, consult your
energy utility.
To Next Page
Loading...
Need help?
General
