Workzone WMW 300-1 - Getting Your Tool Ready

AFTER SALES SUPPORT
USA
Preparation
13
USA
1 866 326-6446
meister-service@meister-werkzeuge.de
Preparation
Checking the multifunction tool and product
contents
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a
sharp knife or other pointy objects, you may damage the mul-
tifunction tool.
− Therefore, be careful when opening it.
1. Remove the packaging material.
2. Check whether the delivery is complete (see fig.A and B).
3. Check whether the multifunction tool or the accessories exhibit damage.
If this is the case, do not use the multifunction tool. Contact the manu-
facturer at the service address specified on the warranty card.
Familiarizing yourself with the functional principle
The multifunction tool does not rotate the fitted tool; instead, it oscillates it back
and forth.
Familiarizing yourself with permissible materials
You can use the following tools to process the listed materials:
Plunge-cut saw blade
• Hard and soft woods
Scraper
• Layers of paint and lacquer
• Synthetic coatings
• Flexible floor coverings, e.g. carpets, linoleum
Segment saw blade
• Hard and soft woods
Sanding plate
• Hard and soft wood surfaces
• Layers of paint and lacquer