AFTER SALES SUPPORT
USA
19
USA
1 866 326-6446
meister-service@meister-werkzeuge.de
Problem Possible cause Troubleshooting
2.
The extractor
line/dust
extractor is
loose/keeps
falling off.
The extractor line/the
dust extractor is not
properly mounted.
Use the holding clips to secure
the extractor line on the housing
of the multifunction tool.
Push the dust extractor firmly
onto the connecting nozzle
of the extractor line and turn
it counterclockwise to fix it in
place.
3.
The multi-
function tool
cannot be
switched on.
The socket has no
power.
Check the socket by connecting
another device.
The power plug has
not been inserted
properly.
Check to make sure that the
power plug is properly seated.
The power plug is
not connected to a
socket.
Insert the power plug in a
socket.
The On/Off switch is
stuck.
Keep the On/Off switch clean
as described in the chapter
“Cleaning and maintenance”.
The power plug/
On/Off switch is
defective.
Contact the customer service
team of the manufacturer.
4.
The tool hol-
der does not
move after
switching on
the multifun-
ction tool.
There is dirt, wood
chips or other objects
located in the gap of
the tool holder.
If necessary, clean the gap of
the tool holder with a vacuum
cleaner.
The multifunction-
tool is defective.
Contact the customer service
team of the manufacturer.
5. The oscilla-
tion/speed
can not be
increased or
decreased.
The speed control is
dirty.
If necessary, clean the speed
control and the gap with a
vacuum cleaner.
Accessories
You can purchase suitable accessories such as sanding sheets from commercial
outlets (e.g. at Bosch).
To Next Page
