Lawn Mowing Robot EN
15
C. Clean the contact pins and the charging strips
Clean the Contact Pins (2) located on the Charging Base (3) and the
Charging Strip (5)located on the Landroid
®
L using a cloth. Remove
any build up of grass clippings and debris around the contact pins
and charge strips periodically to ensure the Landroid
®
L successfully
charges each time.
5.3 Battery Life
The heart of the Landroid
®
L is its 28-volt lithium-ion battery. No
maintenance is required. For proper storage of the battery, make
sure it is fully charged in kept in a cool dry place between (20°C-60°C).
The life-span of the Landroid
®
L’s battery depends on various factors,
such as:
• The time span of the mowing season in your region
• Amount of hours the Landroid
®
L mows per day
• Battery maintenance during storage
Landroid
®
L can be charged manually without the
boundary wire (See Fig. Q).
To manually charge the battery without connecting the
boundary wire to the charging base;
1. Connect the Charging Base to a suitable power
supply.
2. Manually dock the Landroid
®
L into the Charging Base
while the Landroid
®
L is powered off.
3. The charging base red light will turn on.
4. Within 3 seconds and before the charging base light
turns green, press the Landroid
®
L power ON/OFF
button.
5. Landroid
®
L will begin to charge.
5.4 Winter Hibernation
Your Landroid
®
L will live longer and healthier if it is allowed to
hibernate. So even though it is tough, we would recommend that you
store your Landroid
®
L in your shed or garage during the winter.
Before you prepare your Landroid
®
L for winter hibernation, we
recommend you:
• Thoroughly clean your Landroid
®
L.
• Fully charge the battery.
• Turn the mower off.
The battery should be fully charged one time during winter to keep it
in the best possible health for next season.
When storing, lay the Landroid
®
L flat on all four wheels in a dry place
out of icy weather. It is suggested to store your Landroid
®
L in its
original box. It is best to put the Charging Base, Low Voltage Cable
(4), and Transformer (22) indoors over the winter season as well. (See
Fig. R)
The Boundary Wire can be left in the ground although its ends
should be protected, such as placed in a tin can with grease. If the
Charging Base is left outside for winter, leave the Boundary Wire
connected.
NOTE: When bringing the Landroid
®
L back to life after winter
hibernation, make sure the Charging Strips (5) and Contact Pins (2)
are clean, it is best to use a fine grade emery cloth. Then make sure
the date and time are correct and send the Landroid
®
L back to what
it loves doing: mowing.
P
(a)
(b)
R
Q
To Next Page
Loading...
