Lawn Mowing Robot EN
16
• Battery maintenance during storage
Landroid
®
can be charged manually without the boundary wire.
To manually charge the battery without connecting the boundary wire to the Charging Base;
1. Connect the Charging Base to a suitable power supply. The Charging Base green light will turn on.
2.
Manually dock the Landroid
®
into the Charging Base while the Landroid
®
is powered off. (See Fig. P1)
3. The Charging Base green light will turn to red, and the battery indication light will flash green. (See
Fig. P2) Landroid
®
will begin to charge.
9.4 Winter hibernation
Your Landroid
®
will live longer and healthier if it is allowed to hibernate. So even though it is tough, we would recommend
that you store your Landroid
®
in your shed or garage during the winter.
Before you prepare your Landroid
®
for winter hibernation, we recommend you:
• Thoroughly clean your Landroid
®
• Fully charge the battery
• Turn the power off
To maximize the battery life, it is recommended to fully charge the battery before storage during winter.
WARNING: Protect the underside of Landroid
®
from water. NEVER store Landroid
®
upside down
outdoors in case of water inflowing.
The Boundary Wire can be left in the ground although its ends should be protected, such as placed in a tin can with grease.
If the Charging Base is left outside for winter, leave the Boundary Wire connected.
NOTE: When bringing the Landroid
®
back to work after winter hibernation, make sure the Charging Strips (4) and Contact
Pins (2) are clean, it is recommended to use a fine grade emery cloth to clean. Then make sure the date and time are
correct and send the Landroid
®
back to what it loves doing: mowing.
9.5 Replacing the battery
WARNING: Turn power off before attempting any adjustment, replacement or repair.
If you need to replace the Battery, follow these steps:
P1 P2
Q1
a
2
2
1
Q2
To Next Page
Loading...
