Lawn Mowing Robot EN
17
1. Gently turn your Landroid
®
upside down.
2. Remove the screws on the battery cover. Remove the battery cover. (See Fig. Q1)
3. Lift out the old battery carefully. Press the latch (a) and release the connectors. (See Fig. Q2)
NOTE: Do not pull by the cables. Hold the connectors and release the latch (a).
4. Connect a new original battery by attaching the connectors together until it clicks into position. (See Fig. Q3, Q4)
5. Fit the battery as shown. (See Fig. Q5) Place the cover back in its position and firmly fit the screws.
10. Function Messages
The battery indication light on the interface of Landroid
®
indicates the following status:
Battery indication light Status
Green light on Sufficient power for mowing
Red light on Low power, need to recharge
Green light flashing Charging
Green light breathing flashing Standby, waiting for next working schedule.
Red light flashing Battery too hot. Wait until the battery cools down.
11. Security
If Landroid
®
is connected to your smartphone (Only for specific model, please check Technical Data & Declaration of
Conformity), you can lock it on your smartphone. This prevents unauthorised people from being able to use it.
To Next Page
Loading...
