8
2-in-1 Grass Trimmer/Edger
EN
1. ON/OFF SWITCH
2. AUXILIARY HANDLE
3. HANDLE ROTATION LOCKING MECHANISM
4.
HEIGHT ADJUSTMENT LOCKING MECHANISM
5. TELESCOPE TUBE
6. CUTTING HEAD ADJUSTMENT BUTTON
7. MOTOR HOUSING
8. FLOWER GUARD
9. CUTTING HEAD
10. SAFETY GUARD
11. EXTENSION CORD HOLDER
12. LINE CUTTER (See Fig. B)
13. LINE FEED BUTTON (See Fig. H)
14. CUTTING HEAD COVER (See Fig. J)
15. CAP RELEASE LATCH (See Fig. J)
16. SPOOL (See Fig. J)
17. EYELET (See Fig. J)
Not all the accessories illustrated or described
are included in standard delivery.
TECHNICAL DATA
Type WG119E (1-designation of machinery,
representative of Lawn Trimmer and Edge
Trimmer)
Rated voltage 220-240V~50/60Hz
Power 550W
No load speed 8900/min
Max. cutting diameter 30cm
Diameter of line 1.65mm
Line length 2x5m
Weight 2.4kg
Protection class
/II
NOISE DATA
A weighted sound pressure L
pA
=84dB(A)
K
pA
3.0dB(A)
A weighted sound power L
wA
=96dB(A)
Wear ear protection.
VIBRATION INFORMATION
Typical weighted vibration
a
h
= 2.7m/s²
Uncertainty K=1.5m/s²
WARNING! The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10
0
C or less
Plan your work schedule to spread any high vibration
tool use across a number of days.
To Next Page
Loading...
Need help?
General
