1. ON/OFF SWITCH
2. AUXILIARY HANDLE
3. HANDLE ROTATION LOCKING MECHANISM
4.
HEIGHT ADJUSTMENT LOCKING MECHANISM
5. TELESCOPE TUBE
6. CUTTING HEAD ADJUSTMENT BUTTON
7. MOTOR HOUSING
8. FLOWER GUARD
9. CUTTING HEAD
10. SAFETY GUARD
11. EXTENSION CORD HOLDER
12. LINE CUTTER (See Fig. B)
13. LINE FEED BUTTON (See Fig. H)
14. CUTTING HEAD COVER (See Fig. J)
15. CAP RELEASE LATCH (See Fig. J)
16. SPOOL (See Fig. J)
17. EYELET (See Fig. J)
Not all the accessories illustrated or described
are included in standard delivery.
TECHNICAL DATA
Rated voltage 220-240V~ 50/60Hz
Power 550W
No load speed 8900/min
Max. cutting diameter 30cm
Diameter of line 1.65mm
Line length 2*5m
Weight 2.4kg
ACCESSORIES
Flower guard
1
Auxiliary handl 1
Safety guard 1
Spool (WA0007) 1
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for the cutting of grass and
weeds under bushes, as well as on slopes and edges
that cannot be reached with the lawn mower.
WARNING! To avoid injury from unexpected
starting or electrical shock during assembly or
adjustment, do not plug the power cord into a source
of power.
Action Figure
Assembly
Assembling Safety Guard
WARNING: Make Sure the
Safety Switch is Locked Off
to Prevent Accidental Starting.
See Fig. A, B
Assembling auxiliary handle See Fig. C
Pigtail power cord See Fig. D1,D2
Operation
ON/OFF Switch
WARNING! The cutting
head continues to rotate
after the trimmer has been
switched off; wait until it has
completely stopped then lay
down the tool.
See Fig. E
Trimming
Adjusting the Height See Fig. F1
Adjusting the Auxiliary Handle See Fig. F2
Adjusting the Trimmer Head See Fig. F3
Trimming See Fig. F4
Using the Flower Guard See Fig. F5, F6
Edging
WARNING! Always switch
the machine off and remove
plug from power source .
Changing the tool into the Edging
mode
NOTE: The trimmer head will only
rotate in one direction
See Fig. G1, G2
Edging See Fig. G3
Manually feeding the line See Fig. H
To Next Page
Loading...
